|
Post by down4derby on Jan 25, 2010 20:04:02 GMT -7
Hello, I am about to drill my axle holes with the block and was wandering if I should drill my rear canted axle holes 1/16 lower to help level out the body? Also Ive discoverd the table for my drill press is warped via the block. I placed a 9x13 inch mirror on the table for a quick fix, has anybody tried this?
|
|
|
Post by ACME Racing on Jan 25, 2010 21:34:43 GMT -7
You don't want a level car with canted rear axles. There is an exact science behind it and it took me lot's of research to find out why. I used to be an ASE master auto tech 30 years ago and didn't know this stuff. I have learned a ton about aerodynamics and alignment just in this forum and on the web. PS: A big bastard file and a steady hand will get that table flat again.
|
|
|
Post by down4derby on Jan 25, 2010 22:02:19 GMT -7
Are you saying to drill 3 the same or should I go the other way and drill the rear slightly higher front lower to exagerate this effect?
|
|
|
Post by W Racing on Jan 25, 2010 22:22:16 GMT -7
|
|