|
|
Post by Vodka Racing on Oct 2, 2009 12:14:55 GMT -7
I have a set of these but they are difficult to insert into the axle holes. I drilled my holes with a #43 bit and followed up with a pin vise and a different #43 bit. The holes seem clear. How are you inserting them without bending the axle at it's smallest diameter locations?
|
|
|
|
Post by Vodka Racing on Oct 3, 2009 19:16:09 GMT -7
They are the 91s and I've only ventured at getting the tips in the holes. I think the 93s will only be 0.093" at the section that sits inside the wheel hub and the rest of the axle will be like the 91s.
|
|
|
|
Post by W Racing on Oct 3, 2009 20:02:08 GMT -7
WHat drill bit are you using? What brand?
|
|
|
|
Post by Vodka Racing on Oct 4, 2009 12:27:08 GMT -7
WHat drill bit are you using? What brand? Deep black polished looking bit from the local ace hardware store, $1.19 #43 bit. I used a natural steel looking #43 bit in a pin vise to check the axle holes and everything was clean. |
|
|
|
Post by W Racing on Oct 5, 2009 4:28:36 GMT -7
drill bits are all a little diffrent. I use ones from MB4hire / JewkesEngineeriig...
Perhaps try a difffrent bit?
|
|
