|
|
Post by Half Moon Racing on Sept 10, 2009 12:35:16 GMT -7
Any suggestions on determining if slope on track is level. I have a single lane best set-up on an uneven floor. I have levelers/adjusters for the straight sections, but I'm not sure what to do check/adjust the slope section? I have an adjuster on the tall support bracket (the one near the pin) but I don't feel comfortable with assuming that if the support is level, then the track is level. thanks
Ed
|
|
|
|
Post by Fat Boy on Sept 10, 2009 13:29:14 GMT -7
i'll take the first shot at this.
i took a carpenters sqaure a made some pencil marks on mine and use a 6'' level on the slope and shim my stand until all is level.
next
|
|
|
|
Post by P D D R 2 on Sept 10, 2009 14:05:08 GMT -7
i'll take the first shot at this. i took a carpenters sqaure a made some pencil marks on mine and use a 6'' level on the slope and shim my stand until all is level. next As Fat Boy says using a square and level: Use the square on side of the track with the level from side to side resting on the square.... check it both ways left and right.... at the top of track, at starting pin, middle of the hill and at the joint to curve section.... |
|
|
|
Post by Half Moon Racing on Sept 11, 2009 5:20:13 GMT -7
thanks guys. will try the level and square after work today.
Ed
|
|
