|
|
Post by Extreme Racing on Mar 11, 2009 19:28:55 GMT -7
Not sure if I am posting this in the right place. I have read a few post on shipping, the photos are no longer able to be seen.
I have looked at the Toob as well, but I am looking on ideas for more then one car.
I also read about a roll cage, photos are no longer shown.
Thanks in advance
Extreme
|
|
|
|
Post by Zeebzob on Mar 11, 2009 20:02:50 GMT -7
Here is what I do and its worked well so far: Get some 2 inch foam board that they use in home construction - its usually pink or light blue and can be found an any home depot or lowes or what ever. Sandwich the car between two pieces, cutting room for the car in the lower piece. I have a drywall attachment for my dremel tool and I route out the shape of the car to its a tight fit. Then I route for the wheels to be able to spin freely. In the picture, you can see the top of the single car foam piece where the wheels go  |
|
|
|
Post by Extreme Racing on Mar 11, 2009 21:06:33 GMT -7
Zee
Thanks for the photos and input
Extreme
|
|
|
|
Post by Sarge on Mar 12, 2009 6:58:59 GMT -7
  This is what I have used for two years now and haven't had any problems with it. Its ugly but it was cheap. It only cost me a few bucks to make. It works allot like the toob but is a little bit different. You need something to hold the car so that it will not move AT ALL IN ANY DIRECTION. You may get away with using foam rubber a few times but I will guarantee sooner or later you will have problems with damage. |
|
