|
Post by johna745 on Oct 22, 2008 13:22:21 GMT -7
Does anyone know of a way to bore and ream the inner bore of a raw BSA wheel? My son and I are going to try and make a fast car only using what comes in the box I thought the wheel bores might be a good place to start.Thanks
|
|
|
Post by 2FAST4U on Oct 22, 2008 21:07:12 GMT -7
Does anyone know of a way to bore and ream the inner bore of a raw BSA wheel? My son and I are going to try and make a fast car only using what comes in the box I thought the wheel bores might be a good place to start.Thanks i WOULD NOT TOUCH THE WHEEL BORES... YOU HAVE The BLOCK WRIGHT... TAKE A NUMBER 98 OR 99 DRILL BIT CHUCK IT UP BACK WARDS SO JUST ENOUGH OF THE BIT STICKS OUT OF THE DRILL CHUCK SO THE WHEEL WILL PRESS ON THE DRILL BIT... TAKE THE BLOCK START WITH ABOUT 150 GRIT AND WITH THE BLOCK MOVE YOUR FENCE AND THE BLOCK UP AGAINST YOUR WHEEL UNTIL IT TOUCHES THE LOW SIDE OF THE WHEEL AND TURN YOU DRILL PRESS ON SLOW SPEED THEN PUSH THE BLOCK THROUGH THE WHEEL BACK AND FORTH UNTIL YOU MAKE THE WHEEL ROUND THEN MOVE UP TO 400 AND 800 THEN FINISH IT WITH 1000... OR 1500 THIS IS ANOTHER WAY YOU CAN USE THE BLOCK TO GET VERY NICE WHEELS.... I STILL LIKE THE Edge Pure stockrs but you can make a fast set of wheels this way... Glenn
|
|
|
Post by johna745 on Oct 23, 2008 2:35:51 GMT -7
|
|