|
Post by Tye Racing on Apr 20, 2007 20:59:28 GMT -7
i have worked and worked on the front axle of my stock car and cannot get the wheel to stop moving into the car. this happens immediately after the car starts rolling, front or backwards.
the car rolls prefectly straight on a 8ft test track that is elevated 1/2 inch. the back two wheels seem to be very well aligned and dont move on the axle at all, front or backwards rolling.
i have even bent the axle below level so that the wheel rolls on the outside edge and the wheel still moves into the car. seems i cannot prevent it from happening. also, car is balanced from left to right evenly.
any suggestions? i have studied the Pope alignment test and still am baffled.
this was my April stocker (Typhoon) and ran descent times for my first attempt at Stocker. But of course, I WANT SPEED!!!
|
|
|
Post by bjracing on Apr 20, 2007 21:32:51 GMT -7
You said you bent the axle below level. Did you try turning the front axle such that is is above level and riding on the inside edge?
|
|
|
Post by Tye Racing on Apr 20, 2007 21:41:11 GMT -7
just did that and it worked. thanks..
KOH sent me some IM's and fixed my issue. He sensed that i was ready to trash the car and thought he would help me. no need in wasting a good car. ;D
|
|