|
Post by NinjaRabbi on Feb 18, 2007 10:14:01 GMT -7
Any tips for an axle hole that is getting loose (too many times pulling the axle out trying to align)?
Thanks.
|
|
|
Post by Rail Hugger on Feb 18, 2007 10:37:35 GMT -7
Any tips for an axle hole that is getting loose (too many times pulling the axle out trying to align)? Thanks. I sometimes take a very small amount of Elmer's white glue on a toothpick and coat the inside of axle hole, sometimes it takes a couple coats to get it snug.I've also drilled hole out to 3/16" and plugged with 3/16" dowel rod and drilled new axle hole.
|
|
|
Post by F.A.S.T Racing on Feb 18, 2007 12:01:36 GMT -7
Any tips for an axle hole that is getting loose (too many times pulling the axle out trying to align)? Thanks. I hear ya !!! :'(I had the axles in/out of SuperBee so many times trying to get it aligned the hole got a little loose.
A couple of drops of water in the hole then let it sit (at room temp) for a while really snugged-up the holes for me.
I do like the idea of the glue & toothpick....... might try that next time[/b]
|
|