|
Post by Slingblades_Grindhouse on May 25, 2009 19:36:05 GMT -7
Any hints as to how much "bend" a front axle needs to get a razor-wheel car aligned? Seems like it would not take as much as a full tread wheel...or am I way off base...or...just doing WRONG using this method for a Mod. car? Should I drill for toe-in?
Thanks guys
|
|
|
Post by 2FAST4U on May 25, 2009 22:40:38 GMT -7
Any hints as to how much "bend" a front axle needs to get a razor-wheel car aligned? Seems like it would not take as much as a full tread wheel...or am I way off base...or...just doing WRONG using this method for a Mod. car? Should I drill for toe-in? Thanks guys you only need just a little bend not much all...
|
|
creekrat
PDDR Forum Member
[Mo0:0]
Posts: 5
|
Post by creekrat on Nov 8, 2010 23:10:39 GMT -7
are you using the block to drill your holes?if you are drilling your holes with a cant you will not need to bend the nails...I could be wrong I am new to this
|
|
|
Post by W Racing on Nov 9, 2010 0:00:35 GMT -7
are you using the block to drill your holes?if you are drilling your holes with a cant you will not need to bend the nails...I could be wrong I am new to this You are correct. The thread is in refrence to the front wheel that steers into the rail. That particular nail you do bend to allow steer. Best WIshes - W
|
|