|
Post by G Force Racing on Apr 15, 2011 11:07:15 GMT -7
I like to use a fence for my wheel height, also like to add a jig to repeat my wheelbase. I found when the block is flat on the table and a hole is drilled and when a hole is drilled with the pin under the block (canted 3Deg) the distance between holes center to center is approx. .224".
|
|
|
Post by G Force Racing on Apr 15, 2011 11:12:03 GMT -7
I found when using the Block, the distance between canted (pin under 3 deg) and flat on the table is approx .224''
|
|
|
Post by G Force Racing on Apr 15, 2011 11:15:47 GMT -7
Sorry for the double post internet crashed & didn't know 1st post was sent.
|
|
|
Post by *5 J's* on Apr 15, 2011 11:20:30 GMT -7
I found when using the Block, the distance between canted (pin under 3 deg) and flat on the table is approx .224'' ?? hmm, I don't have the numbers here, but I thought it was more like 2/32" or 0.0625".
|
|
|
Post by azgreg on Apr 15, 2011 11:39:32 GMT -7
I found when using the Block, the distance between canted (pin under 3 deg) and flat on the table is approx .224'' Recheck your measurments, that is close to 1/4 inch.
|
|
|
Post by *5 J's* on Apr 15, 2011 11:45:01 GMT -7
I found when using the Block, the distance between canted (pin under 3 deg) and flat on the table is approx .224'' Are you putting the pin under the correct groove?
|
|
|
Post by Zeebzob on Apr 15, 2011 13:19:52 GMT -7
I found when using the Block, the distance between canted (pin under 3 deg) and flat on the table is approx .224'' Not sure about that...the pin itself is .125"
|
|
|
Post by G Force Racing on Apr 16, 2011 11:35:15 GMT -7
Sorry everybody I posted before thinking (sometimes talk that way too). I got all excited when I went to my notes and opened right to what I thought I was looking for. It hit about 5 hours later after I starting thinking about a different layout, that things didn't add up. wrong: .224'' I have .097'' written down.
|
|
|
Post by *5 J's* on Apr 16, 2011 15:12:38 GMT -7
Sorry everybody I posted before thinking (sometimes talk that way too). I got all excited when I went to my notes and opened right to what I thought I was looking for. It hit about 5 hours later after I starting thinking about a different layout, that things didn't add up. wrong: .224'' I have .097'' written down. 0.97" sounds much better. I have never measured butr I know it's clsoe to 1/16"
|
|
|
Post by 2FAST4U on Apr 16, 2011 18:09:34 GMT -7
I like to use a fence for my wheel height, also like to add a jig to repeat my wheelbase. I found when the block is flat on the table and a hole is drilled and when a hole is drilled with the pin under the block (canted 3Deg) the distance between holes center to center is approx. .224". i hope everyone usesssssssss a fence when drilling with the block.... lol
|
|