|
Post by littlezracer on Jan 8, 2011 0:25:36 GMT -7
I was wondering how low is to low to hang the weight from the bottom of the car. We are running a 3 wheel RR with the the axel holes being drilled with the Block. Right now we have a square block of lead that we are useing. ( have not bought the sweet spot yet) right now it is about 3/16th of an inch below the car. Just wondering if I will have enough room. Thanks in advance. The track is an older wooden one. Thanks again.
|
|
|
Post by W Racing on Jan 8, 2011 1:23:29 GMT -7
You will want to measure from the center of the rear axle hole to the bottom of the lead. What is that measurment?
Or if the wheels are on the car you can slide a 1/4" to 3/8" plywood, etc... under the car to check for clearance...
|
|
|
Post by littlezracer on Jan 8, 2011 3:22:47 GMT -7
The plywood trick should work. We'll have to try that. We are on the begining stages so no wheels on yet. Thanks.
|
|